DRAGON DRIVER

Mode Groups:

1- low red,high red,ml,5,15,35,50,100
2- low red,high red,5,15,35,100
3- low red,ml,5,15,35,50,100
4- low red,5,15,35,100
5- low red,high red,15,100
6- low red,15,100
7- ML,5 ,15,35,50,100
8- 5,15,35,100

Reversing options(1/2second press) as follows:
Turbo--->Strobe--->Batt Check (1-8 with 8 being full) ---> Bike Indicator Strobe

Configuration Options:

p>To enter configuration mode, quickly turn off the light 15+ times until it starts to flash. Once it starts to flash, you are in configuration mode. 
Once in configuration mode, the light will give a solid flash between 1 and 5 times. The number of solid flashes indicates the option number to be changed. To select/change the option turn the light off and back on during the strobing flashes that immediately follow the solid flashes. When you choose option 1 it will start to flash 1-8 times, turn off and back on after the number of the group you want comes up. When setting the temperature control the light will go from programming to turbo, turn the light off when it reaches the temperature you desire. 

1. Mode Group Select.
2. Memory Toggle.
3. Mode Order Toggle. 
4. Temperature Calibration Mode.
5. Reversing Toggle.

********************************************

QUANTUM DRAGON DRIVER

Mode Groups:

* Group 1: Color, ML, 5%, 15%, 35%, 50%, 100%
* Group 2: Color, ML, 35%, 100%
* Group 3: ML, 5%, 15%, 35%, 50%, 100%
* Group 4: ML, 5%, 15%, 100%
* Group 5: ML, 15%, 100%
* Group 6: 5%, 15%, 35%, 50%, 100%
* Group 7: 15%, 100%
* Group 8: 15% - 50%
* Group 9: 100% Only
* Group 10: Color, 100%
* Group 11: 100%, Color
* Group 12: Color, 50%
* Group 13: 50%, Color

Configuration Options:

To enter configuration mode, quickly cycle the switch 12+ times until it starts to flash. Once it starts to flash,
you are in configuration mode. Once in configuration mode, the light will give a solid light and ramp down, if you
want to modify options 2-4 cycle switch during ramp to move to next option.
* Option 1 = Mode group, when light ramps down it will flash all 3 colors and then the group number in white light
followed by all 3 colors. To select the group flashed in white light cycle the switch in the next color cycle
after the group number you want to use is blinked out.
* Option 2 = Secondary color choice, when light ramps down it will blink twice to show its in the second option
and flash each color several times, cycle switch while the color you want to use is flashing.
* Option 3 = Memory on/off, when light ramps down it will blink three times to show you its in the third option
and flash red or green several times. Cycle the switch while flashing red if you want memory off and green if you
want memory on.
* Option 4 = Strobe option, when light ramps down it will blink four times to show its in the fourth option and
flash each color several times, cycle switch while flashing red for off, green if you want standard strobe and
blue for bicycle mode. To access these in normal use cycle switch rapidly three times and it will access either
strobe programmed when turned on.